Description

• ---

  Product Description

  

  

  read installation menu before installing

  This device will not turned on without proper fitting and water pressure , for check this you call the plumber and get installed this device and find that device is not working this happens when someone buy this and installed this without reading its minimum requirements. So every time before installing or retuning it back to us kindly get installation help from given link on user manual as we have not found even a single not working device among thousands

  • You can’t control the temperature of this device, input power 220v ac and load is 3 kw

  Water Heating Instantaneous

  Kitchen bathroom washroom

  ABS engineering plastics, high temperature resistant, soft and strong, not easy to burst high shape stability. Strong anti-stamping, UV radiation, so the product is not easy to aging security is more durable and lasting. Water consumption information: Under the condition of 0.1MPa water pressure The maximum flow of hot water is 2.4L/ min, and the maximum flow of cold water is 3L/ min.

  • Digital display to show real time temperature but it will show nothing when you plug in and turn on the power until unless geyser will get proper water flow pressure.
  • If there is a low pressure problem, please don’t buy it as it will not work there.
  • This geyser gives you instant hot water in a few seconds, make sure temperature not to cross above 70 degree.

  Digital display

  

  No temperature control in this device

  when you turn on this heater tap temperature will be normal as per your cold water temperature such as 25 degree but within 2 minutes temperature may cross to 50 degree as it has 3 kw element design for highly cold area due to its small size there is no option for controlling the temperature.

  therefore we do not recommend it for direct uses in normal cold areas

  

  Don’t buy if there is Low water pressure

  you might have seen in comment section that few people say – this device is very good and for same few say it is a worst product . the reason behind is nothing except water pressure .

  if water pressure is low then no such heater will work there even if you replace this 1000 times.

  

  No mix water in this heater either hot or cold only

  If you are purchasing this heater to get look warmed mixed water then don’t go for it as this heater will give you either cold water or very hot water only you have mix it yourself.

  in simple language you can not control it’s temperatur

  

  Support and well-being

  Support and well-being of dual-use electric faucet, while heated, the water, the lower the temperature, whereas the smaller the flow, the higher the temperature.

  

  Water tankless

  When you receive Dr Water tankless instant electric tap water heater, please do not test it in your hands, you need install it well and then test, or it will be dangerous. Please operate it according to the instructions.

  ABS engineering plastics, high temperature resistant, soft and strong, not easy to burst high shape stability. Strong anti-stamping, UV radiation, so the product is not easy to aging security is more durable and lasting. Water consumption information: Under the condition of 0.1MPa water pressure The maximum flow of hot water is 2.4L/ min, and the maximum flow of cold water is 3L/ min.It may not be possible to maintain a large flow of water. Before purchase, please make a clear distinction between Below Inflow and Lateral Inflow to avoid unusable conditions. Big Under Bend, Small Under Bend, Big Lateral Bend, Small Lateral Bend. 3 to 5 seconds fast heat. In general, to say at least, the temperature at about 20 degrees to 40 degrees in winter & 30 degrees to 50 degrees in summer, depending on the quantity of flowing water. Vertical upward installation is required, not inclined or inverted installation. For the first time, please turn on the cold water and then the power supply. It is strictly forbidden to install the water purifier, water purifying faucet, and other blocking original parts, so as to avoid affecting the normal outflow of the machine and hindering the heating of the machine, thereby damaging the machine. After each use, cold water should be placed for a while before the switch is closed to prolong the life of the heating pipe.